R0015263 Mount drive motor for load shaft

instructions to mount loading arms drive shaft motor

Difficulté

Medium Moyen

Durée

1 hour(s) heure(s)

R0015263_Mount_drive_motor_for_load_shaft_Screenshot_2023-07-04_190535.png

Introduction

Tools Required

Standard Hex key set

Standard Spanner set

Long nose pliers

Parts Required

B0000041 Feather Key 5 x 5 x 18 Long x 1

B0000142 Feather key 5 x 5 x 25 long

B0000240 Geared Motor 0.18kW 18RPM Motovario x1

B0001100 Feather Key 8 x 7 x 30 Long x2

D0006714 Index Torque Limiter (B0189 / B0190) x1

D0015460 Infeed Motor Shaft (2018) x1

D0015461 Infeed Motor Mount x1

D0015462 Infeed Motor Platex1

F0000618 m10 x 70 set bolt

Étape 1 - Unless otherwise stated

Use loctite 243 on all fasteners

Use Loctite 572 on all threaded pneumatic connections

Pen mark all bolts to show finalised

Étape 2 - Assemble Motor

1 Fit2 off B0001100 keys to D0015460 shaft and fit and orientate as shown. Use 24mm external circlips to captivate shaft front and back

2 Attach D0015462 infeed motor plate using M8 x 20 socket caps 4 off and M8 A form washers. Orientate as shown

3 Fit B0000041 key to shaft. Separate torque converter D6714 by removing duplex chain and attach Fixed side of torque converter as shown. Captivate with15mm external Circlip

Étape 3 - Attach motor mount

Attach Infeed motor mount to frame using F0000618 M10 x 70 set bolts and A form washers

Ensure mount plate is mounted square to blue channel

Do not apply final tension as this will require adjusting

Étape 4 - Torque convertor clutch Quality checks

1 Inner spacer must pass though drive sprocket by hand , vital for correct clutch operation

2 Correct assembly order of components

1 Lock nut

2 Locking washer

3 Spring washers 3 off

4 Pressure plate

5 Friction plates 2 off 1 either side of drive sprocket

6 Drive sprocket

7 Inner spacer

8 Clutch body

9 Fixed clutch body

10 Duplex chain and duplex chain joiner

Étape 5 - Attach torque converter

Fit B0000142 Key to drive shaft and position torque convertor

Do not tension grubscrew at this point

Étape 6 - Attach motor

Attach motor assembly using M10 x 30 cap heads and A form washers

Étape 7 - Adjustment

Adjust mounting parts to achieve the following

1 2 parts of torque converter line up and are parallel to each other

2 Shaft is in correct position (direction shown ) to allow correct fitment of torque converter

3 Finalise fasteners including torque converter grubscrew

Étape 8 - Fit duplex chain

Fit duplex chain to mounted parts of torque converter

Ensure all parts are fitted including centre section

Étape 9 - Lock off Drive shafts

Apply adhesive and lock off all grubscrews in spherical bearings in all positions (9 off bearings )

en none 0 Draft