Motors need to be wired to allow 240v 3 phase operation , Change from Star to Direct on Line/Delta We only need to fit 1 Clutch spring plate - Not all 3 springs on the Crank

Also Done to F031 - Who use ZEB FDS label Width set to 832 Left margin offset -30 (3mm)

On the original FDS Zeb files the label format is for 102mm Width to get the new printers to work you need set width at 832 (102mm) and in Advanced settings set left Position at -30 (-3mm) which will allow the label to work on a 99mm width

Z071 -- also needs the -30 (3mm) left position offset - Uses FDS Zeb files originally set to 101mm

Use an Orbital sander to do this job, Video shows it being done by Hand

Z108 - Has been updated

4 x G clamps are Required It is for 2 x People - 3 days

Z055 - ZX4 has been fitted using existing Software setup so Ou_InvDP not used (24v linked to S3 and S4.X308 - Inverter Zero fitted but not used. Uses Drive Run Fwd not using SMOT.

STO alarm Please see https://stuga.dokit.app/wiki/Yaskawa_Inverter_-_Fault_and_Alarm_Output_Functionality Once wiring changes have been made, change parameter H2-03 to 110. This can be done online via DriveWizard or directly through the inverter touchpad.