ZX5 MH Infeed Basic IO Test and Setup

Guide for basic Input and Output testing / setup on the ZX5 MH Infeed Module

Difficulté

Medium Moyen

Durée

4 hour(s) heure(s)

ZX5_MH_Infeed_Basic_IO_Test_and_Setup_Full_infeed.jpg

Introduction

The MH infeed on a ZX5 is a module which can be tested individually away from the fully installed machine. Once build stage is complete, to be able to test individually, the Infeed Module needs:

- To be connected to mains power & be powered on

- An air supply to the main blue line

- Network connection (Network Cube)

- HDMI & Keyboard dongle to be plugged into the Beckhoff PLC inside the cabinet.

Input and output activation when testing the sole module is done through the Twincat project rather than through WinMulti

The above is only required If the Machine is not fully installed and connected with power air and network already.

Étape 1 -

en none 0 Draft