Details for fitting main turntable assemble to main frame
Auteur Gareth Green | Dernière modification 9/11/2023 par Gareth Green en cours de rédaction ⧼frevu-button-review-label⧽
Details for fitting main turntable assemble to main frame
R0015328_Install_Base_and_Turntable_Screenshot_2023-10-20_101941.png
Tools Required
Standard hex key set
PPE Gloves
Parts Required
D0015663 SR Axis Motor Guard x 1
R0000558E Bench Assemble Base and Turntable Mk5 x 1
All bolts to have Loctite 243 adhesive applied unless otherwise stated
All Threaded Pneumatic connections to have Loctite 570 applied
All bolts to be pen marked once adhesive applied and correct tension added
Fitting of turntable base requires a 2 man lift to fit into position
Ensure the following are observed before commencing fitment
Pinch points are present when fitting base. Ensure all handlers are aware of dangers
Ensure handlers are aware of full procedure for fitting
ensure routes are clear of obstacles and work area is safe for lifting
Ensure all components on base are correctly tensioned before commencing lifting
Ensure correct handwear is used for protection
Ensure correct manual lifting method is used by individuals
3 person lift
1 Manoeuvre assembly in from side of frame as shown, lifting assembly at an angle
2 when entered frame , lower rear section first onto mounting angles
3 Lower front section onto mounting angles
4 adjust position of frame to align M8 taped holes and slots in frame
1 Captivate with 1 off for each corner with M8 x 50 socket caps and large and medium heavy m8 washers
2 Remove tension on front two grubscrews in shafts (non dimpled shaft position)
3 Use fitted M8 bolts on rear tie bar to pull to frame
4 Use front m8 socket caps to pull front tie bar to frame
Add adhesive to all 4 off securing grubscrews that hold onto shafts and finalise tension
en none 0 Draft
Vous avez entré un nom de page invalide, avec un ou plusieurs caractères suivants :
< > @ ~ : * € £ ` + = / \ | [ ] { } ; ? #