ACEpc Network Software - IP

Setting up a ACEpc with the NETSETGO software to interface with an IP address to a Windows XP or earlier computer.

Difficulté

Easy Facile

Durée

10 minute(s) minute(s)

• Tutoriels prérequis

Tutoriels prérequis

ACE PC Re-Flash

Étape 1 - Insert disk (Power off)

Étape 2 - Power On

Étape 3 - Proceed with format Y

Volume label [enter]

This will format the hard drive and then copy all necessary network software as a ZIP file to the hard drive and then inflate it.

Étape 4 - NetEdit Saw Name

Build number must be unique. If a flowline saw put an "s" on the end. i.e. F073S

Étape 5 - Saw IP address

Supplied by customer.

If testing in house it needs to be on the 192.168.16.xxx range.

e.g 192.168.16.101

Étape 6 - Multi Name

If this is for a Flowline - Build Number of Flowline machining center

Otherwise this will be the net NETBEUI name of the pc you are connecting to.

For testing at stuga this will be NAS1

Étape 7 - Multi IP

If this is for a Flowline - IP Address of Flowline machining center

Otherwise this will be the IP address of the pc you are connecting to.

For testing at stuga this will be 192.168.16.6

Étape 8 - Save + Exit

Press escape - then Y

Unable to open params.saw file is normal.

Étape 9 - Remove Disk + Reboot

Successful if D:\ prompt.

Étape 10 -

en none 0 Draft