Correct installation , setting and quality checks for installation of material sensor beam
Difficulté
Difficile
Durée
1 heure(s)
Sommaire
Introduction
Tools Required
Standard hex key set
2 Meter straight edge
Parts Required
R0015060 Bench Assemble Flapper Beam
Étape 1 - Unless otherwise stated
Use Loctite 243 on all fasteners
Use Loctite 572 on all threaded pneumatic connection
Pen mark all fasteners to show finalised
Étape 2 - Attach mounting brackets to module C and E
Attach mounting brackets as shown
Étape 3 - Position and fix Assembled beam
(front transfer beam removed for clarity )
Fix assembled beam to supports as shown
Do not finalise fasteners
Étape 4 - Set height of assembled beam
Use sliding adjustment on maytec angles /frame to adjust height of assembly
To determine correct height Set end A and B separately
Étape 5 - Setting Height
Span over transfer beams 1 and 2 with straight edge at point A
Lift or lower sensor rail assembly to match the following criteria
When straight edge is pushed to meet radius of sensor plate, it must strike at indicated point of halfway around radius on paddle
Étape 6 - Repeat at point B
Repeat height setting at point B using same criteria
Once point B is set, check that point A has not altered
Étape 7 - Finalise fasteners
Once correct settings have been achieved, double check and finalise all fasteners used for adjusting and mounting .
Ensure all fasteners have 243 applied to threads and are pen marked as complete
Draft
Français
English
Deutsch
Español
Italiano
Português