Correct installation , setting and quality checks for installation of material sensor beam
Difficulté
Difficile
Durée
1 heure(s)
Introduction
Tools Required
Standard hex key set
2 Meter straight edge
Parts Required
R0015060 Bench Assemble Flapper Beam
Étape 1 - Unless otherwise stated
Use Loctite 243 on all fasteners
Use Loctite 572 on all threaded pneumatic connection
Pen mark all fasteners to show finalised
Étape 2 - Attach mounting brackets to module C and E
Attach mounting brackets as shown
Étape 3 - Position and fix Assembled beam
(front transfer beam removed for clarity )
Fix assembled beam to supports as shown
Do not finalise fasteners
Étape 4 - Set height of assembled beam
Use sliding adjustment on maytec angles /frame to adjust height of assembly
To determine correct height Set end A and B separately
Étape 5 - Setting Height
Span over transfer beams 1 and 2 with straight edge at point A
Lift or lower sensor rail assembly to match the following criteria
Draft
Français
English
Deutsch
Español
Italiano
Português