R0015279 Align Backfences

Procedure for correct alignment of module E back fences

Difficulté

Hard Difficile

Durée

2 hour(s) heure(s)

R0015279_Align_Backfences_Screenshot_2023-07-14_140401.png

Introduction

Tools Required

Standard hex key set

Standard spanner set

Wire Line setting equipment

600mm rule

Workshop Gripper setting jig

2 meter straight edge

Parts Required

Fitted and Levelled roller bed assemblies

Étape 1 - Unless otherwise stated

Use Loctite 243 on all fasteners

Use Loctite 572 on all threaded pneumatic connection

Pen mark all fasteners to show finalised

Étape 2 - Set position 1

Set backfence position 1 to have a gap of 3mm at the indicated point

Étape 3 - Measure Position 1

Take measurement at indicated point

Étape 4 - Set position 10

Set position 10 to measure taken in previous step from position 1

Étape 5 - Add wire line to backfences

Fit wire line to backfences to span all

Étape 6 - Ensure only positions 1 and 10 are contacting

Ensure all positions of backfences except 1 and 10 are not touching wire line

Étape 7 - Adjust each backfence

Individually adjust each backfence to be less than 1mm from wireline but not touching

Étape 8 - Finalise alignment

The first 2 meter section of backfences from position 1 should now be fine tuned with a 2 meter straight edge

Position 2 meter straight edge against indicated points

Étape 9 - Quality /alignment check

Use steel rule to measure each backfence position from hepco rail

Measurement taken in step 3 should indicated at all backfences if set correctly .

Étape 10 - Gripper position setting

Gripper position requires setting now that back fences are aligned

The following steps should be followed for correct alignment

Étape 11 - Use setting jig

Ensure setting jig is set against position 1 backfences

Ensure setting jig is orientated correctly , correct offset of holes towards backfence

en none 0 Draft