[version en cours de rédaction]

Version actuelle datée du 15 septembre 2023 à 15:05

Lots of complex problems bringing a pre v6 saw (with beckhoff pre-v6 also) Notes to follow if this is needed again

Pas encore d'image

Lots of complex problems bringing a pre v6 saw (with beckhoff pre-v6 also) Notes to follow if this is needed again

Sommaire

Very difficult to get front and back end to talk if the twinCAT versions are different. Update both to 4024

Update front end software to v6

Add to versionControl

v6 used GX, older versions sometimes used SX

useOffcutAtStart=1
en none 0

Draft

@@ Ligne 4 : / Ligne 4 : @@
 |Categories=Software
 }}
-<translate>= Start from Scratch =
+<translate>=Start from Scratch=
 Very difficult to get front and back end to talk if the twinCAT versions are different. Update both to 4024
@@ Ligne 11 : / Ligne 11 : @@
 Add to versionControl
-= SX / GX Axes =
+=SX / GX Axes=
 v6 used GX, older versions sometimes used SX
-* Axes.mul (rename to GX and axis is 1)
+*Axes.mul (rename to GX and axis is 1)
-* Clamps.mul (GX not SX) - copy clamps.mul from S012
+*Clamps.mul (GX not SX) - copy clamps.mul from S012
-* Project link to arrAxes[10]
+*Project link to arrAxes[10]
-* Project axis naming
+*Project axis naming
-<br /></translate>
+= Parameters =
+useOffcutAtStart=1<br /></translate>
 {{PageLang
+|Language=en
 |SourceLanguage=none
 |IsTranslation=0
-|Language=en
 }}
 {{AddComments}}