R0015356 Assemble Pneumatics on to electrical cabinet

Instructions to mount pneumatic components

Difficulté

Medium Moyen

Durée

3 hour(s) heure(s)

R0015086_Assemble_Pneumatics_on_to_electrical_cabinet_Screenshot_3.png

Introduction

Tools Required

Standard hex keys

Standard spanner set

Standard drill set

Standard tapping set

Tape measure

Rule

PartsRequired

P0001069 x 1

P0001022 x 1

D0001933 x 1

P0001008 x 1

P0000010 x 3

P0001009 x 1

P0001102 x1

P0000009 x 1

P0001163 x 4

P0001073 x 1

P0000159 x 3

P0001101 x 1

Étape 1 - Unless otherwise stated

Use loctite 243 on all fasteners

Use Loctite 572 on all threaded pneumatic connections

Pen mark all bolts to show finalised

Étape 2 - Drill position for regulator bracket

Use dimensions to fix regulator bbracket P0001022 to cabinet. Drill 2 off M5 tapped holes to suit regulator. Use m5 x 12 socket caps and heavy M5 washers

Étape 3 - Drill position of Valve

Mount valve bracket D0001933 to dimensions shown . Measurements are taken from edges of cabinet to first top mounting hole of bracket . Use valve bracket to mark second hole after first hole is drilled . Drill and tap M5

Étape 4 - Drill position of valve base

Drill valve bank base to dimensions shown. Measurements are taken from edge of cabinet to mounting hole indicated. Once first hole is drilled, use valve base as template to add 3 off remaining fixing points. Drill and tap M4

Étape 5 - Assemble and mount regulator

Assemble regulator P0001008 as shown. Use P0001009 panel nut and 2 off P0000010 fitting and mount to bracket on cabinet

Étape 6 - Assemble and mount Valve

Assemble P0000458 valve with fittings shown. Mount to bracket on cabinet using M5 x 12 socket caps and M5 heavy washers

Étape 7 - Assemble valve base and fit

Assemble valve base P0001069 with fittings shown

Mount to cabinet using 4 off M4 x 40 socket caps and M4 A form washers

Étape 8 - Mount trunking

Cut 40 x 60 Trunking (p n/o required ) to length to suit cabinet width with no overhang . Position height wise referencing the cable access shroud

Drill and fix with m5 x 10 button heads and large A form washers .

...Check where m5 tapped holes are added . Inside the cabinet there are mount bosses to accept electrical panel. Ensure areas to drill are selected that don't interfere with these points

en none 0 Draft