| [version en cours de rédaction] | [version en cours de rédaction] |
| Ligne 20 : | Ligne 20 : | ||
{{Tuto Step | {{Tuto Step | ||
|Step_Title=<translate>Press button with profile in place</translate> | |Step_Title=<translate>Press button with profile in place</translate> | ||
| − | |Step_Content=<translate></translate> | + | |Step_Content=<translate>Hold button in until yellow light flashes, let go</translate> |
}} | }} | ||
{{Tuto Step | {{Tuto Step | ||
|Step_Title=<translate>Press Button with profile removed</translate> | |Step_Title=<translate>Press Button with profile removed</translate> | ||
| − | |Step_Content=<translate>This sets the longest range of the sensor</translate> | + | |Step_Content=<translate>This sets the longest range of the sensor. |
| + | |||
| + | Hold until flashing stops</translate> | ||
| + | }} | ||
| + | {{Tuto Step | ||
| + | |Step_Title=<translate>Check that it works</translate> | ||
| + | |Step_Content=<translate></translate> | ||
}} | }} | ||
{{Notes}} | {{Notes}} | ||
Version du 10 septembre 2019 à 17:05
How to set ultrasonic sensor on an infeed table
Difficulté
Facile
Durée
2 minute(s)
Vimeo
Étape 1 - Ensure there is 30mm clearance from sensor to profile
If the sensor is closer, it will not work
Étape 2 - Press button with profile in place
Hold button in until yellow light flashes, let go
Étape 3 - Press Button with profile removed
This sets the longest range of the sensor.
Hold until flashing stops
Étape 4 - Check that it works
Draft
Français
English
Deutsch
Español
Italiano
Português