Upgrade Autoflow to Windows 10

Steps to upgrading an Autoflow to Windows 10, replacing both the front end and back end PCs

Difficulté

Hard Difficile

Durée

1 day(s) jour(s)

Autoflow, Windows 10, Upgrade Upgrade_Autoflow_to_Windows_10_c6015__web_main.jpg

Introduction

Upgrading an Autoflow to Windows 10 involves upgrading two PCS

1. The Beckhoff control PC
2. The Camera PC

The Beckhoff PC is not upgradable so needs to be completely replaced. We use the miniature Beckhoff C6017 for this

It is not cost effective to upgrade and old camera PC, so a new one is supplied

Étape 1 - Set up the 6017 PC

• Ensure regional settings correct - correct date format
• Rename the Ethernet Adaptors to Ethernet and EtherCAT
• Ensure the TwinCAT Protocol is installed on the EtherCAT adaptor
• Teamviewer setup
• Administrator password set to "Stuga001"
• Add Stuga desktop image
• Latest winMulti in c:\multi

Étape 2 - Set up New Camera PC

Follow standard Setup procedure to step 5 to ensure sourcetree installed with latest tc3Multi software pulled to machine

Étape 3 - Add the backup to cameraPC

In folder c:\DDRIVE

Copy latest messages.saw to DDRIVE

Étape 4 - Convert the TC2 project from old machine

Follow this procedure to convert the project

Map the Saw On, Conveyor and extractor as outputs rather than invertergofwd links (outputs 97 and 98)

Ensure the PLC projects are in the correct ports

851- tc3multi

852 - PLC_Reset

Étape 5 - Install the new PCs on site

• Ensure the 6017 PC has been earthed adequately

Étape 6 - Set up the IP addresses

Map the network drives

Map customer network connections

Étape 7 - Test all IO

This is important to ensure there have been no mistakes in the remapping

Étape 8 - Test axis directions

Étape 9 - Test axis Datuming

Étape 10 - Check Spindles and alarms

Check inverter is wired so that OK=high on X90

Check alarms trigger on low signal on inverter ok

Check 50Hz and 300Hz spindles function correctly from SpindleIO screen

...A lot of the older machines were released with inverter OK active low, and the alarms file set up to "bodge" around this. The "correct" way should be active high which means it is also fail safe. Take this opportunity to ensure the machine is correct

Étape 11 - Important parameters

Ensure:

autoQueue=1

syAxisType=1
allWasteAtStart=1

throwaway=230

throwawayChunkSize=120

throwawayEjectAtStart=1

storeOffcuts=0

Étape 12 - Check cut speeds

The software highlighted a bug in the calculation for the saw cutting speed which has now been corrected. Saw cut speeds should be checked if they are not default.

...The old software calculated the percentage based on the cut height, not the speed! It was not noticed because the cut height would be around 70-150mm (70-150%) so would not look excessively fast or slow

en none 0 Draft