R0015319 Fit Guards and Doors

Details for guard fitting

Difficulté

Medium Moyen

Durée

4 hour(s) heure(s)

R0015319_Fit_Guards_and_Doors_Screenshot_2023-11-01_164027.png

Introduction

Tools Required

standard hex key set

Standard spanner set

Standard HSS drill set

Standard tap set

Long reach 4.2mm drill

Extended M5 tap

Parts Required

R0015321 Bench assemble guards and doors

Étape 1 - Unless otherwise stated

Use locktite 243 on all fasteners

Use loctite 572 on all threaded pneumatic connection

Pen mark all fasteners to show finalised

Étape 2 - Fit roof panel

Fit pre assembled roof panel

Étape 3 - Fit rear panel

Fit re assembled rear panel

Étape 4 - Alignment

It is vital that door locks should align correctly.

Handle operation should be smooth and no force required to engage locking pins

Any discrepancies should be reported

Étape 5 - Fit Guard Doors

Fit 4 off Pre assembled guard doors to hinges

Étape 6 - Drill door lock pins

Drill off door lock pins and strike plates

Étape 7 - Drill and set interlock switches

Set and drill door interlock switches

Ensure door switches are set correctly. Interlock blade must fully penetrate the guard switch, and align with no catching as entering the interlock

Étape 8 - Fit Front panel

Fit front upper front panel

en none 0 Draft