R0015259 Mount roller beds to mainframe

Fitting details for completed assemblies

Difficulté

Medium Moyen

Durée

2 hour(s) heure(s)

R0015259_Mount_roller_beds_to_mainframe_Screenshot_2023-07-04_094602.png

Introduction

Tools Required

Standard Hex key Set

Standard spanner set

Parts Required

Completed Assemblies

R0015081

R0015090

Étape 1 - Unless otherwise stated

All bolts to have Loctite 243 adhesive applied unless otherwise stated

All Threaded Pneumatic connections to have Loctite 570 applied

All bolts to be pen marked once adhesive applied and correct tension added

Étape 2 - Sequence for mounting assemblies has been updated

Build sequence has been modified for improved access to key stages of build

Drive shafts will now be fitted before roller beds , this being enabled by a change to the bench assembly process of the roller beds .

Étape 3 - Fitting roller Beds

Please take photos of these steps for update

1 Position Bracket on blue section , holding roller frame upright

2 Fix bracket with M8 x 25 socket caps and heavy M8 washers

3 Lower roller frame to 90 degrees

4 Wind cylinder thread into attached rod end bearing

Étape 4 - Roller bed Positions

See Pictures for R0015081 and R0015090 roller bed locations

Étape 5 - Attach to Frame

1 Mount assemblies as shown using M8 x 25 socket caps and heavy M8 washers.

Do not apply Loctite 243 at this stage to bolts

Only apply enough tension to fasteners to hold roller assemblies true to the mounting face (Blue section)

2 Attach R0015081 using the same fasteners as above. Ensure the slots are used to align to the other roller bed assemblies as shown

en none 0 Draft