R0015315 Fit Y Axis Drive components

Fitting instructions for Y Axis drive

Difficulté

Medium Moyen

Durée

0.5 hour(s) heure(s)

R0015315_Fit_Y_Axis_Drive_components_Screenshot_2023-09-28_122448.png

Introduction

Tools Required

Standard hex key set

External circlip pliers

Parts Required

B0000344 Circlip 15mm External x 1

D0001927 Intermediate Housing (AM3032) x 1

D0006487 Y Stepper Housing x 1

R0000962E Bench assemble Y axis Components

Étape 1 - Unless otherwise stated

Use Loctite 243 on all fasteners

Use Loctite 572 on all threaded pneumatic connection

Pen mark all fasteners to show finalised

Étape 2 - Fit Y axis sleeve assembly

Insert pre built Y axis sleeve as shown

Étape 3 - Fit stepper housing block

Fit Y axis stepper housing block as shown

Ensure block is mounted square and true

Pay attention to bearing fit

If bearing is loose, used solvent and bearing fit adhesive

Étape 4 - Position leadscrew

Slide leadscrew into position shown

Étape 5 - Fit bearings

Fit 2 off bearings and captivate with circlip

Étape 6 - Final leadscrew position

Slide leadscrew into final position

Add M8 x 12 kcp grubscrews to secure leadscrew to sleeve

Étape 7 - Finalise leadscrew nut

Finalise position of leadscrew nut using 4 off M6 socket caps and a form washers

Étape 8 - Check movement

Check axis movement along entire length .

Movement should be free and consistent

Étape 9 - Fit servo adapter block

Dry fit servo adapter block

do not add final tension to this block

Étape 10 - Fit servo motor

Fit servo motor to adapter block

Servo should fit easily into servo adapter block

~Adjust position of adapter block if fit is not correct

Étape 11 - Finalise servo adapter block

Remove servo motor and finalise fasteners on servo adapter block

Étape 12 - Re fit servo motor

Ensure motor is orientated correctly , servo plug facing down

Finalise socket caps fixing motor to adapter block

Étape 13 - Fit keyway locking grubscrew

Fit locking grubscrew accessed through indicated hole

Étape 14 - Check movement

Check Axis movement again. There should be no change in consistency of movement or force required

If changes are evident , investigate !

en none 0 Draft