Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.
Liste de résultats
- 1 Connect 2 off 12mm red pipes from transfer basket to saw air service unit Connect 1 off 12mm blue pipe from Module E saw infeed table +
- 1 Position base of laser on cut table and … 1 Position base of laser on cut table and cast beam towards gripper 2 Position Gripper directly Infront of laser and mark horizontal line on gripper to match laser dot 3 Move Gripper to point one indicated , and inspect horizontal line to laser dot . Any discrepancy can be adjusted by the 2 off adjusting floor bolts directly below 4 Repeat this step and indicated points 2,3 and 4t this step and indicated points 2,3 and 4 +
- 1 Rotate the laser so the base is against … 1 Rotate the laser so the base is against the rear roller fence, and position the gripper at its closest point of travel to the saw . 2 Project the laser to the gripper, and mark a vertical line on the gripper Adjust Saw module in directions shown to align the laser to the vertical mark on gripper 3 Move gripper to end of infeed frame , and inspect laser mark 4 Adjust saw module as shown to correct laser mark onto grippers shown to correct laser mark onto gripper +
- All settings should be double checked once final adjustments have been made Machine level Laser alignment Grip pin positions Back fence alignments +
- Check with 2meter straight edge alignment … Check with 2meter straight edge alignment of infeed rollers All rollers should be level to each other, with no bumps onto adjacent rollers when straight edge is moved across. check this at front and rear section of roller beds to confirm roller bed levels are correct alsoconfirm roller bed levels are correct also +
- Connect permanent air feed to lift module E rollers to the lifted position +
- It is vital before the next step is performed that cut tables are accurately levelled. Double check that tables are level after height adjustment. Tolerance -+ 1 division on engineers level +
- It is vital to confirm Cut tables are in t … It is vital to confirm Cut tables are in the correct position once levelled, and that movement hasn't occurred during transport To do this the base of the saw turn table must be checked for level. These readings must read exactly the same as the levelled cut table in the previous step Any discrepancy should be reporteds step Any discrepancy should be reported +
- Once above step has been completed, both cut tables should be inspected for flatness Use 1 meter straight edge on top face of cut tables and use 0.02" feeler gauge to inspect flatness of tables +
- Position module F at end of Module E infeed frame Approximately Align Saw roller back fences to Saw infeed back fences Approximately align X axis position by setting the to frames spaced at the distance shown of 20mm +
- Saw module should be raised or lowered to … Saw module should be raised or lowered to align with blue load rollers on saw infeed table Saw module should sit above blue rollers by no more than 1mm Ensure levels previously set are not compromised when adjusting height Double check levels are still correct once height has been adjustedtill correct once height has been adjusted +
- Set deflection plate to be 4mm behind backfences of Saw and Infeed table and finalise position +
- Use the indicated points to level the frame. Use cut table indicated as levelling point Level Y and X Axis of saw +
- With the laser still casting along the infeed table, slowly return the gripper along the axis and inspect the laser dot in relation to lines added to gripper. Discrepancy should be less than 4mm on both axis +
- X axis position is determined by gripper travel Y axis position is determined back fences Z axis is determined by cut table to infeed roller height +
Français
English
Deutsch
Español
Italiano
Português