Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• Link type should be Igus code 15.050.100 f … Link type should be Igus code 15.050.100 for 100mm radius on the bend.
  ...There has been a problem with identification of these parts and the wrong bend diameter may have been sent (15.050.048)
  
  and the wrong bend diameter may have been sent (15.050.048)</div> </div><br/>  +
• MH outfeed - 5.37metres 177 Links approx … MH outfeed - 5.37metres 177 Links approx Saw infeed - 4.46metres 154 Links approx Make sure when the gripper is pushed to the end (back) of the rack, the bend of the chain isn't either falling out of the trays or too tight and riding up against the guarding fence.
  ...Note these values are for a standard 6.5m machine. A 6.0m will have less
  se values are for a standard 6.5m machine. A 6.0m will have less</div> </div>  +
• Make sure the cables and piped are fixed with cable ties to the fingers of the bracket to avoid movement or twisting inside the energy chain.  +
• Test this by moving the gripper up and down on a reversing cycle in twincat. Start slow and work up to full speed  +
• The Bracket to which the finger energy chain bracket fixes to should not rub or catch on the trays during movement Also the fold of the energy chain shouldn't ride along the side of the trays when moving towards the multi or saw end  +
• There should be 3 reversed links at the motor end of the chain leading to the 'finger' bracket See [[Igus Energy Chain Installation]]  +
• To avoid any contact with the button heads … To avoid any contact with the button heads which fix the trays to the 'L' brackets adjust the brackets on the slots. Tray heights are also important, make sure there is a consistent gap (consistent as possible) between the top of the bend and the top tray all the way along. The end corners of the trays may require bending out slightly, there have been occasions where one chain tray has been slightly more bent in than the other meaning when the chain moves from one tray to the next it clips the corner of the next tray.next it clips the corner of the next tray.  +