Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• # With the GY at zero, move the GX axis t … # With the GY at zero, move the GX axis to the last roller before machining centre # Check the gripper position relative to backfence # Check to see if this is within the adjustment range of the infeed roller
  
  ...If the roller has "run out" of adjustment, go back to step 1 and readjust the start point (and GY datum position) to give enough range to get both ends within the range
  
  um position) to give enough range to get both ends within the range</div> </div><br/>   +
• #Datum the machine and move GY axis to ze … #Datum the machine and move GY axis to zero, GZ to 25 #Place the jig against the backfence and offer it up to the Gripper Jaw #If the GY datum is set correctly, the rear outer face of the jig should be just in contact with the rear serrated jaw #If this is not the case, set GY datum correctly his is not the case, set GY datum correctly   +
• If the backfence to gripper is different in this location, it will be visible by a gap or interference to the jig Move GY axis (in 0.25mm increments) to make it touch Log GX value vs the GY value in your table / spreadsheet <br/>  +
• If you have the 2m straight  +
• PASS The error should be within +/- 1mm a … PASS The error should be within +/- 1mm along the rack In the given example of measurements, the overall range was 0 to +1.5mm Therefor the GY axis datum should be adjusted by+0.75mm so the error range will then be -0.75mm to +0.75mm(within tolerance FAIL If the error variance is outside this range, the backfence will need to be rest to correct thisfence will need to be rest to correct this  +
• There may be areas where the offset changes more than others - these deserve more detailed inspection with closer GX axis increments  +
• Using the straight-edge, ensure the infeed rollers are 0-1mm behind the machining centre datum rollers .  +