Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• <div class="icon-instructions caution-i …
  ...Ensure maytec barrel fittings are positioned on inside face
  Assemble main maytec frame Ensure all sections are set in a parallel position '''Please capture pictures for this please'''tions are set in a parallel position '''<u>Please capture pictures for this please</u>'''  +
• Assemble 4 off mounts Ensure maytec fittings are orientated correctly Ensure spring clip is fitted to D nut <br/>  +
• Check issued stainless plates 2 off have been countersunk correctly M4 countersunk should sit flush, not above top of stainless sheet  +
• Conveyor can be built in 2 formats L-R R-L Please see picture for clarification of orientation  +
• Ensure all fasteners are finalised on frame  +
• Fit 3 off blower fittings to mounting points on bearing cheeks  +
• Fit belt to assembly '''<u>Photos required in correct sequence please</u>'''  +
• Fit drive roller assembly as shown Ensure spacer washers are fitted Ensure blower point is orientated correctly to suit belt rotation direction Should be at bottom of frame on opposite side of drive motor <br/>  +
• Fit drive flange to bearing cheek ensuring … Fit drive flange to bearing cheek ensuring correct orientation to allow correct fitment of motor Fit motor to bearing flange, do not apply final tension or adhesive to locating grubscrew as motor will need to be removed later on It is important to test fit at this stage to identify correct fitment
  stage to identify correct fitment <br/>  +
• Fit mid rollers  +
• Fit slave roller assembly as shown Ensure spacer washers are fitted Ensure blower points are orientated correctly to suit belt rotation direction <br/>  +
• Fit supplied adhesive tape to top face of frame at shown points '''<u>Photos required in correct sequence please</u>'''  +
• Quality check all fasteners ensure all fasteners have adhesive applied, are correctly tensioned and are pen marked to indicate finalised  +
• Set lower roller tension (motor end) Measure and set gap to 15mm either side <br/>  +
• Tension drive roller to 22mm gap at both sides of roller Ensure both sides are set to the same measurement <br/>  +
• Use Loctite 243 on all fasteners Use Loctite 572 on all threaded pneumatic connection Pen mark all fasteners to show finalised  +
• Use stainless plates as a guide to align M … Use stainless plates as a guide to align M4 plate nuts before removing adhesive tape backing
  
  ...Ensure stainless plates are aligned correctly. They should be parallel to maytec main frame
  Once aligned , remove adhesive tape backing and secure stainless plates into position Fit 8 off supplied m4 countersunk hex sockets to finalise stainless plate fitting
  ion Fit 8 off supplied m4 countersunk hex sockets to finalise stainless plate fitting <br/>  +
• indicated 3 roller housings will require blower holes adding Mark Blowers as shown . Drill through with 2.5mm drill Then drill half way from outside face with 4.2mm drill Then tap outside face shown M5  +
• insert 8 off supplied m4 plate nuts into correct face of long frame sections 4 off per side  +