Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.
Liste de résultats
- Add 4 off M8 x 20 KCP grubscrews to points shown . Adjust grubscrews to touch dowels +
- All bolts to have Loctite 243 adhesive applied unless otherwise stated All Threaded Pneumatic connections to have Loctite 570 applied All bolts to be pen marked once adhesive applied and correct tension added +
- Attach R0000562 Bench assemble centralise top table as shown Use 4 off M8 x 20 socket caps Fit assembly at highest position in slots Dry fit fasteners, apply medium tension +
- Check settings are adjusted, check that Z block operation does not foul cut tables To do this move both z blocks by hand to active and home position and check contact is not made with the cut tables +
- Check that no adjustment grubscrews are loose. Any grubscrews that are not required should still have adhesive applied and lightly tensioned to set in position +
- Drill4 off dowel points in saddle brace 5.8mm to a depth of 20mm Ream to 6mm H7 tolerance Use 4 off 6mm x 20 dowels to secure +
- Ecr raised 12/12/23 to amend turret bracket D0015416 and D0015417 hole size to 6mm Amend hole size by hand to 6mm until +
- Fit 2 off 1/2" x 1" dowels to frame as shown . Ensure dowels are fully seated . Ensure chamfered end of dowel is inserted first Secure with 2 off M8 x 12 KCP grubscrews +
- Fit 4 off M8 x 12 flat bottomed grubscrews to the points shown Wind grubscrews to touch frame +
- Fit H0004543 Gap cover saw finger guard to assembly Use 3 off M5 x 12 socket caps and A form washers finalise fasteners +
- Fit turret assemblies to brackets using 6 off M6 x 16 socket caps and A form washers +
- Mount R0015037 Bench assemble SY Assembly Use 8 off M6 x 20 socket caps Dry fit fasteners +
- Once height has been adjusted, roller squareness must be checked and reset if movement has occurred . Both height and squareness will have to be manipulated together to achieve all settings to requested specification +
- Recheck all settings once dowelled to ensure no movement has occurred +
- Recheck all settings once final adjustment has been made Roller squareness to cut tables Roller height to cut tables Parallel to back fences +
- Recheck all settings once final adjustment has been made Roller squareness to cut tables Roller height to cut tables Parallel to back fences +
- Remove turret brackets ( required for later step of dowelling) Individually remove and apply adhesive to all dry fasteners and apply final tension +
- Set height of Sy assembly to cut tables us … Set height of Sy assembly to cut tables using jacking grubscrews Release pressure on front 4 off M8 x 20 socket caps Use M8 x 20 grubscrews to adjust height of assembly Set to gap of 1.5mm -+ 0.5mm Ensure assembly sits level/even across all rollers Apply final tension with adhesive to front M8 x 20 socket capswith adhesive to front M8 x 20 socket caps +
- Set initial position of assembly using engineers level on the indicated axis Use M8 squareness adjusting grubscrews to set position Set both positions level +
- Use 2 off straight edges against back roller fence Add offset shim of 0.002"/0.05mm to driven side Set front rollers to touch, using M6 socket caps and counter bore clearance to adjust Report if unable to achieve parallel from this movement +
Français
English
Deutsch
Español
Italiano
Português