Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• All bolts to have Loctite 243 adhesive applied unless otherwise stated All Threaded Pneumatic connections to have Loctite 570 applied All bolts to be pen marked once adhesive applied and correct tension added  +
• Attach infeed clamp assembly to infeed pad Use 2 off M8 x 35 socket caps Do not use adhesive at this point  +
• Clearance between clamps and saw blade mus … Clearance between clamps and saw blade must be checked. To do this 1 Lift saw blade to maximum height 2 Rotate turntable to 45 and 135 degrees (full travel in both directions ) 3 Clearance should be evident between saw blade and clamps in the area shown Report to supervisor if contact is present Please take photos to show this check Please take photos to show this check  +
• Fit outfeed clamp assembly to outfeed pad sing 2 off M8 x 50 socket caps and M8 motor plate washers Do not use adhesive at this point  +
• Individually remove and apply adhesive to 4 off M8 fasteners and apply final tension setting to 40nm with torque wrench <br/>  +
• Recheck alignment once final tension is added to all fasteners Check all clamps more freely up and down pillars when quip clamp has tension removed  +
• Use 1 meter straight edge along pillars Adjust '''OUTFEED CLAMP''' to set all 4 pillars to contact straight edge Use feeler 0.002" /0.05mm gauge as maximum tolerance  +
• Use soft hammer to adjust pillar position to be flush with cut table Check position using engineers square as shown Add final tension to M8 securing fasteners  +