Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.
Liste de résultats
- Check Axis movement again. There should be no change in consistency of movement or force required If changes are evident , investigate ! +
- Check axis movement along entire length . Movement should be free and consistent +
- Dry fit servo adapter block do not add final tension to this block +
- Ensure motor is orientated correctly , servo plug facing down Finalise socket caps fixing motor to adapter block +
- Fit 2 off bearings and captivate with circlip +
- Fit Y axis stepper housing block as shown Ensure block is mounted square and true Pay attention to bearing fit If bearing is loose, used solvent and bearing fit adhesive +
- Fit locking grubscrew accessed through indicated hole +
- Fit servo motor to adapter block Servo should fit easily into servo adapter block ~Adjust position of adapter block if fit is not correct +
- Insert pre built Y axis sleeve as shown +
- Remove 4 off fasteners attaching leadscrew nut to bearing block This is required for rotary ring installation at a later stage +
- Remove servo motor and finalise fasteners on servo adapter block +
- Slide leadscrew into final position Add M8 x 12 kcp grubscrews to secure leadscrew to sleeve +
- Slide leadscrew into position shown +
- Temporarily fix position of leadscrew nut using 4 off M6 socket caps and a form washers +
- Use Loctite 243 on all fasteners Use Loctite 572 on all threaded pneumatic connection Pen mark all fasteners to show finalised <br/> +
Français
English
Deutsch
Español
Italiano
Português