Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• Ecr raised 10/10/23 to add 2 off M4 tapped holes to frame. Until processed add by hand as shown  +
• Fit 2 off rivnuts to required mounting poi … Fit 2 off rivnuts to required mounting points for conveyor . 2 off M8 rivnuts must be installed correctly 1 Face of frame must be countersunk to allow flush fitment and full contact of rivnut shoulder. 2 Rivnuts must be tensioned correctly when installed. If in doubt, please request information from supervisor for the correct fitting of rivnuts. 3 Rivnuts should have a solid fixed into frame and not be able to rotate . To check this, bolt a component to the rivnut and tighten. Then undo fastener and remove component. Rivnut should not move during this process and remain solid move during this process and remain solid  +
• Fit 4 of D0004584 Outfeed Side Rest to pos … Fit 4 of D0004584 Outfeed Side Rest to positions indicated When fitting side rests ensure that they are set as shown S 1 Use M6 x 10 socket caps (4 off) to fit indicated arms to frame 2 Use M6 x 12 socket caps and penny washers (4 off) to fit indicated side restshers (4 off) to fit indicated side rests  +
• Fit D0004583 Outfeed Long Rest orientated … Fit D0004583 Outfeed Long Rest orientated as shown Tap all holes in long rest before fitting . Only use a plug tap to clean threads in long rest 1 Use 4 off M6 x 12 socket caps with M6 A washers and fix to frame
  
  ...Only use straight hex keys to tension these bolts. Use of a ball ended hex key will result in fastener and tool damage
  2 Check flatness with 2 meter straight edge across 2 indicated points. Straight edge will show a gap in the centre section of the long rest bar 2 indicated points. Straight edge will show a gap in the centre section of the long rest bar  +
• Fit H0005136 Outfeed Top Tray as shown Ensure indicated faces are set flush to frame Use 8 off M6 x 12 socket caps and heavy M6 washers to fix to frame  +
• Shims can be used to adjust the flatness o … Shims can be used to adjust the flatness of the long rest plate Cut shims to 10mm x 140mm Place at indicated points between frame and long rest bar . Re tension bolts once shim is added to show true reflection of change made by shim added Adjust until long rest bar is flat to straight edge Tolerance + - 1mmlat to straight edge Tolerance + - 1mm  +
• Use Loctite 243 on all fasteners Use Loctite 570 on all threaded pneumatic connections Pen mark all bolts when finalised  +
• Use taps to clean all threads present on frame . Add 4 off m12 x 100 set bolts with M12 nuts and fit to adjusting points Use 4 off levelling pads (workshop stock ) to sit beneath adjustment bolts (pictures required please)  +