Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• 1 Clamp panel in place. Set equal position side ways and flush to top face 2 Drill 8 off M6 tapped holes as shown 3 Drill and tap M5 , then countersink to allow flush fitment of M5 countersunk bolt  +
• 1 Drill 4 off marked holes on hood to M6 tapped , add small countersink to face indicated to aid fitment to frame 2 Drill rear tray to 7.5mm at points indicted by grubscrews  +
• 1 Drill infeed and outfeed chute inserts 1 off M6 tapped per insert Align as shown <u>'''Pictures required please'''</u> 2 Drill and fit main rear chute as detailed  +
• 1 Fit 16 off M8 x 16 socket caps with M8 … 1 Fit 16 off M8 x 16 socket caps with M8 A form washers at the points indicated. Add loctite 243 as fitting bolts Leave enough clearance for trays to slot over 2 Position stainless trays as shown 3 Adjust height of trays to fit flush with top of frame and finalise bolts to secure top of frame and finalise bolts to secure  +
• 1 Mark 4 off fixing points with 7.5mm drill 2 Mark 3 off rear hood points by using M6 x 10 pointed grubscrews , winding into lower panel and impacting with hammer 3 Set top hood position even to front tray 4 Remove hood from frame  +
• 1 Position door above rear chute panel <u>'''Pictures of below required please'''</u> 2 Align height so inner door lip is below chute panel lip 3 check to of door is above frame top crossmember 4 Drill 4 off M6 tapped holes for fixing to frame  +
• 1 Drill marked positions to correct core size (please provide size) for M5 rivnut. Add small countersink to hole to allow flush fitment 2 Use rivnut applicator to insert and fix 2 off M5 rivnuts  +
• 1 Lift hood onto frame 2 Clamp hood into position , ensuring all faces are set flush with frame  +
• Drill and tap additional M5 at point indicated, drill through 1 position 125mm 2 position 25mm <br/>  +
• Drill hinge panel as detailed 1 Clamp p … Drill hinge panel as detailed 1 Clamp panel in position equalising edges to frame 2 Drill vertical face holes onto frame M6 tapped 3 Mark 4 off holes with M6 pointed grubscrew 4 Drill 4 off to 7.5 mm 5 Check correct drilling by fixing panel with M6 socket capslling by fixing panel with M6 socket caps  +
• Remove all panels Clean all swarf from frame and clean paintwork  +
• Set front tray flush with all edges shown … Set front tray flush with all edges shown Mark and drill Panel M6 tapped, Ecr raised to amend panel 10/11/23
  ...Front corner shown may catch weld on frame when mounting, this may require rework
  
  y catch weld on frame when mounting, this may require rework</div> </div><br/>  +
• Set rear tray flush with all edges shown Mark and drill Panel M6 tapped,  +