Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• 1 Use a metre straight edge to bridge bet … 1 Use a metre straight edge to bridge between the top faces as shown 2 Use a engineers level to check level position of the extension section 3 Adjust jacking bolts to raise or lower the extension leg to achieve level
  
  ...Ensure jacking bolts are both turned exactly the same amount when adjusting height. Failure to do this will result in y axis level being affected
  
  ght. Failure to do this will result in y axis level being affected</div> </div><br/>  +
• 1 A wire line should be used as shown to c … 1 A wire line should be used as shown to check alignment. Movement in the direction shown by the arrow is what is being set in this step.
  
  ...Wire line can be attached to front or rear face of frame for alignment. Pick the side that highlights a gap along the wire line as this will make setting easier to see
  2 Move the frame in the indicated direction to achieve a straightness between all the uprights of the frame
  he indicated direction to achieve a straightness between all the uprights of the frame <br/>  +
• 1 Fit levelling jig to frame extension section as shown 2 Use engineers level to adjust the level with the floor jacking bolts to set the jig level  +
• 1 Shim can be added to the section as show … 1 Shim can be added to the section as shown . This shim will correct the face of the box section to allow it to maintain alignment when tightened . Various sizes may be required. Trial and error is the only way to determine what size is required for this purpose Shimming is complete when the fasteners are tightened and the alignment is not affected
  and the alignment is not affected <br/>  +
• Check all alignment and levels have remained after final fixings of fasteners  +
• Now all Fasteners should be tightened and alignment and level Rechecked. Sometimes due to the nature of the structure , it is possible movement will occur when tightening fixings If this is the case , follow next step, if not proceed to step 7  +
• Remove all fasteners one by one, and add Loctite 243 to bolt, retighten and mark bolt heads as complete Arrows indicate bolts to be finalised  +
• The parts should be assembled as shown in … The parts should be assembled as shown in the picture . Use M10 x 25 socket caps and A form washers
  
  ...Adjustment will be required so only add fastenings with no adhesive at this stage , and do not tighten bolts
  
  stenings with no adhesive at this stage , and do not tighten bolts</div> </div><br/>  +
• Use loctite 243 on all fasteners Use Loctite 572 on all threaded pneumatic connections Pen mark all bolts to show finalised  +