Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• 1 Assemble deflector probes as shown 2 … 1 Assemble deflector probes as shown 2 Attach to infeed clamp assembly using Dry M8 x 20 kcp grubscrew 3 Adjust length of probes to be 1mm Above bottom of clamp block 4 Apply adhesive and lock off and finalise all M16 nuts 5 Remove assembly from clamps M16 nuts 5 Remove assembly from clamps  +
• 1 Attach large cylinder to infeed clamp as … 1 Attach large cylinder to infeed clamp assembly using 2 of M6 x 35 socket caps , apply adhesive but only light tension 2 Insert pre built roller clamp assembly. Take care to not damage bearing seals when fitting shaft ,Apply adhesive to cylinder thread and wind into clamp block 3 Ensure cylinder is contracted and tension M10 cylinder nut and 2 off m6 socket caps to set alignment. Check movement is even and no tight spots are evident at ends of cylinder stroke 4 Finalise all fasteners 5 Repeat for Eject clamp side using 2 off M6 x 30 socket caps to fix shorted cylinder6 x 30 socket caps to fix shorted cylinder  +
• 1 Fit hard stop assembly to clamp head. Us … 1 Fit hard stop assembly to clamp head. Use 2 off M6 x 16 socket caps to fix ,only apply light tension to this bolt to allow adjustment 2 Fit cylinder to hard stop bracket and attached cylinder piston to mounting plate , do not apply adhesive on either 3 Contract cylinder and tension all fixing points Ensure clamp movement is smooth and consistent with all fasteners tightth and consistent with all fasteners tight  +
• All bolts to have Loctite 243 adhesive applied unless otherwise stated All Threaded Pneumatic connections to have Loctite 570 applied All bolts to be pen marked once adhesive applied and correct tension added  +
• Once alignment is achieved, fasteners must … Once alignment is achieved, fasteners must be finalised 1 Remove cylinder 32mm locknut an pull cylinder back. This gives access to 2 off M6 socket caps to finalise individually 2 Refit 32mm locknut applying adhesive to thread and finalise 3 Retract cylinder thread and nut, apply adhesive and finalise Repeat for other clamp assemblyinalise Repeat for other clamp assembly  +
• Slide assemblies together as shown Tare care not to damage bearing seals Remove excess grease from shafts once installed Once fitted, check movement is free and consistent  +