Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• 1 End of copper blower should be flattened … 1 End of copper blower should be flattened to allow a vertical blow pattern across the front of newly fitted ultrasonic sensor 2 Use A0001046 P clips to secure blower pipe in place 3 Use P0000069 tube connection on end of copper pipe Ensure when fitting copper pipe that no contact is made onto rotating rollerst no contact is made onto rotating rollers  +
• Completed set up by following guide [[Setting Ultrasonic Sensor - Horizontal]]  +
• Disconnect blower feed to assembly 6mm pipe will be connected to remove assembly via push fit connections. Remove pipe from connections (may not be present on some machine variants ) Assembly can now be removed fully and disregarded  +
• Disconnect switch/sensor. Depending on variant fitted either Unscrew M8 plug connection to disconnect for sensor style Or Disconnect 2 off fork connections onto rear on switch  +
• Fit new ultrasonic sensor E0001120 as shown using mounting block D0010973 Ensure cable E0001104 is fitted to sensor before mounting, and cable is fed through access point before finalising position of sensor  +
• Remove old material load assembly from mac … Remove old material load assembly from machine. Held on by 2 off M6 socket caps indicated 2 Disconnect switch/sensor. Depending on variant fitted either Unscrew M8 plug connection to disconnect for sensor style Or Disconnect 2 off fork connections onto rear on switch 3 Disconnect bloweronto rear on switch 3 Disconnect blower  +
• Route new cable to connection point previously used to disconnect old sensor cable.  +
• Trace back cable fitted to old sensor and disconnect at connection box.  +
• Use attached drawing to connect new sensor to terminal rail in connection box  +
• Use original switch assembly blower line t … Use original switch assembly blower line to feed new copper blower Add P0000160 inline flow regulator to allow correct adjustment of air flow to blower Note, if no blower line is present for the old assembly, a blue pipe line can be used to provide a permanent feed to the blower.to provide a permanent feed to the blower.  +