Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.
Liste de résultats
- * Add air temporarily to the lift rollers to create datum in their up position. * Use laser to level and set height so that the M/C Outfeed rollers are parallel to M/C Rollers, but 0.5-1.0mm lower than the M/C Rollers. +
- * Measure up diagonals to get the two tra … * Measure up diagonals to get the two transfer frames fully parallel. * Measure the gap between the frames, ensuring the male posts on the stub arms (on frames) are same distance as the hole centres on the transfer beams. * Level the frame. * Position Transfer Arms 1 and 9 to fine tune the frame positions. * Place a level on these two transfer arms. * Level the frame again using the two transfer arms to indicate if the Saw Infeed frame needs to be raised or lowered. * Recheck level and squareness of Saw Infeed. Recheck level and squareness of Saw Infeed. +
- <br/>
*Use the aluminium setting ji …
*Use the aluminium setting jig with the gripper holes. *Clamp the jig with the clamps (manually, as air is not switched on yet) *Move the frame and use the gripper as the guide to drop into the holes. *Use laser to align the frame in parallel with the backfence, taking care not to lose the gripper position relative to the gripper holes. *With the outfeed beam in its fully extended position, and the gripper at the end of travel, there gripper should not be able to clash with the infeed top clamp. This should leave the end of the beam 40-60mm from the MH Cross Bar
h the infeed top clamp. This should leave the end of the beam 40-60mm from the MH Cross Bar<br/> + - No hard pipe under the Saw. +
Français
English
Deutsch
Español
Italiano
Português