Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• * Alignment of the popup ins on crank C, D, E to hepco * Using Hepco as datum, ensure they are parallel   +
• * Backfences aligned * Front fences aligned * Back and front parallel   +
• * Check backfence roller alignment to infeed * Check roller heights to infeed and outfeed   +
• *Fixed distance 2-3mm *Has to be clear of transfer beams in the up position   +
• *Pusher bar is behind saw rear rollers *Pusher bar is straight   +
• *Straightness of MH side with laser level … *Straightness of MH side with laser level *Levelness of MH side with carriage plate. Use the carriage plate to check X and Y levelling *Straightness of saw side with laser level *Levelness of saw side with carriage plate *Parallelism of hepco beams to each other with tape rule Adjust to get this correct - adjust frames on floor if not parallel ct - adjust frames on floor if not parallel   +
• <div class="icon-instructions dont-icon …
  ...Moving the saw is a major step, so double check your steps if this becomes necessary
  *Saw module level *Eject beds level and aligned *Backfence 0-1mm in front of saw infeed backfences *Beds 0-1mm above infeed rollersligned *Backfence 0-1mm in front of saw infeed backfences *Beds 0-1mm above infeed rollers  +
• Adjusting Gripper Y position to suit Jig … Adjusting Gripper Y position to suit Jig Grip pressure as low as possible Check gripper gap so the switch is set up correctly [https://stuga.dokit.app/w/ZX5%20Datum%20and%20Grip%20Pin%20Setup ZX5 Datum and Grip Pin Setup] Set first and last backfence, then use a string
  ...When setting long backfences be careful not to distort them when fixing the two anchoring points
  
  ful not to distort them when fixing the two anchoring points</div> </div><br/>  +
• Check with beam at the HOME position (outside machine) and beam in the OUT position (inside machine) Check pressure - as low as possible Check gripper gap so the switch is set up correctly [[ZX5 Datum and Grip Pin Setup]]  +
• Misses gripper by 1mm - should not touch … Misses gripper by 1mm - should not touch Parallel all the way down Channel bar should be just over 1 bar - able to push profile to backfence
  ...Too much pressure will cause the fence to distort
  
  ext">...Too much pressure will cause the fence to distort</div> </div><br/>  +
• Use the linear rail as the datum <br/>  +