Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• # Measure between the VI blade and the ed … # Measure between the VI blade and the edge of the 10mm slot – This value is the xoffsetVI (and also the xoffsetWI).  (We need to add 5mm to the measured Value). ''' 50.33mm''' # Measure between the VO blade and the edge of the 10mm slot – This value is the xoffsetVO (and also the xoffsetWO).  (We need to add 5mm to the measured Value) '''87.59mm'''
  ...The 5mm is added becasue this is half the 10mm slot width - thus measuring to the centreline of the slot
  
  0mm slot width - thus measuring to the centreline of the slot</div> </div><br/>   +
• #Make sure the Datum is correct first. #V … #Make sure the Datum is correct first. #V notch blades are not buckled. #Check that the profile width is correct for the profile you are testing. Find out which V Notch files the machine is using by checking the operation setup. A simple way of doing this is shown in the pictures by starting a "Manual Input". Picture 1 - shows this machine uses VF / VR codes Picture 2 - shows a different machine using VAF3 codes Note this "mnd type" for later
  ...The VF... codes are the original method of setting up the machines, the VAF3 codes are seen as an improvement because it makes the naming of the variables for the offsets a little clearer and groups them together. It also improves the machine cycle time by allowing the use of startOffset - the x axis needs to move only once to the start of the V notch
  
  he x axis needs to move only once to the start of the V notch</div> </div><br/>   +
• #Set the xOffsetVI and WI to the new val … #Set the xOffsetVI and WI to the new value settings. THIS VALUE IS ALWAYS POSITIVE #Set the xOffsetVO and WO to the new value in settings. THIS VALUE IS ALWAYS NEGATIVE Depending on the software version, there are 4 places where these settings are stored / edited es where these settings are stored / edited   +
• A calibration mnd file has been written to … A calibration mnd file has been written to help line up the  x offsets called VTEST. This program creates the following pattern on the bottom of the profile using a 10mm spindle and the notching blades themselves: Run the VTest operation on a length of large outer frame of at least 1m long. Put the    operation at a position of 500mm. The pattern allows you to measure the offsets required with calipers.
  
  ...Profile is viewed from the bottom face, Basically turn it over when it comes of the transfer table.
  
  face, Basically turn it over when it comes of the transfer table.</div> </div><br/>  +