Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• <div class="icon-instructions caution-icon"> <div class="icon-instructions-icon"><i class="fa fa-exclamation-triangle"></i></div> <div class="icon-instructions-text">...This is a very important final step to prevent the clutch coming loose</div> </div>  +
• Ensure the top and side infeed clamps are off Bring the wheel onto the profile  +
• Ensure there are no height spots or differ … Ensure there are no height spots or differences in height between the infeed and outfeed table that prevent the smooth transition of the profile into the machine Activate the side and top infeed clamps with the profile inside, check again that it slides easily -the top and side clamps should be on 2 barthe top and side clamps should be on 2 bar  +
• Move the x axis to 4000mm so there is a clear test runway  +
• Now the clutch has been tightened to overc … Now the clutch has been tightened to overcome the infeed clamp forces, see if you can still slide the bar with the wheel done and the infeed clamps on. It should be more difficult, but it should be possible to overcome the forces.
  ...If you cannot overcome the forces manually, then there is something wrong
  If this manual test fails, there could be one or more of these problems: * Too much down pressure on wheel * Clutch is too tight * Friction / tightness in a roller * A non-rolling part of the table or fence sticking out causing frictiontness in a roller * A non-rolling part of the table or fence sticking out causing friction  +
• Pressure should be set to 1 bar - any more … Pressure should be set to 1 bar - any more than this creates too much drag for the clutch wheel to overcome
  ...The wheel has considerable weight, it does not need much more from an additional cylinder
  le weight, it does not need much more from an additional cylinder</div> </div>  +
• The clutch should have a friction plate each side of the pulley wheel  +
• The wheel clutch tension should be set so you can still manually push the profile and out of the machine. The wheel should turn (ie should not not skid on the profile) but there should be obvious tension. Adjust the clutch tension if to suit  +
• Try same test again with the infeed clamps on. The clutch needs to just overcome the friction created by the side clamps  +
• Use the heaviest profile you can find - a … Use the heaviest profile you can find - a full bar of door T or transom Place it under the wheel so it can be fed into the machine
  ...Ensure the infeed flights are out of the way
  
  ons-text">...Ensure the infeed flights are out of the way</div> </div><br/>  +
• With the wheel on the profile, try the wheel motor on The bar should drive in. If the clutch slips, turn motor off, tighten clutch, try again <br/>  +