Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• 1 Route 6mm tubing through Y axis energy … 1 Route 6mm tubing through Y axis energy chain as shown 2 Fit 6mm y connector, and route additional 6mm tubing from Y connector as shown ( This y connector is fitted to stop pipe crimping on energy chain full movement 3 Tie new 6mm tubing to original loom exiting energy chain up to Tool break sensor assemblyrgy chain up to Tool break sensor assembly  +
• 1 Connect 5 meter length of 6mm tubing to port shown on pilot valve and route into trunking at the same point as previous fitted tubing 2 Route pipe to point shown 3 Continue routing to trunking exit point  +
• 1 Position valve bracket approximately as shown 2 Mark holes through bracket, Drill and tap through marked holes to M5  +
• 1 Remove fitted P0000159 6mm blank from indicated port on main valve bank and connect 6mm black tubing , route through trunking and exit next to pilot valve 2 Connect to port shown on pilot valve  +
• 1 Use 8mm Y connector to feed 8mm blue tub … 1 Use 8mm Y connector to feed 8mm blue tubing from original 8mm blue pipe feeding V notch cut valve 2 Connect to shown port on valve 3 Fit valve with mounting bracket to underside on angle plate, using 2 off M5 x 12 socket caps and 2 off A form washers to fixocket caps and 2 off A form washers to fix  +
• Assemble Valve and Y connector as shown  +
• Connect top tubing section as shown, ensuring Flow restrictor is added to the line and correctly orientated to allow flow regulation when adjusted (this can be tested once functioning ) Secure new tubing to original loom with tie wraps  +
• Drill 7mm hole in D0001962 to dimensions shown. These are approximate dimensions for ease of fitting -+ 5mm  +
• Insert copper pipe into drilled hole and hold in place with 6mm elbow tube tube fitting  +
• Manipulate 6mm copper pipe as shown , approximately form and finalise on fitting  +
• Map to FB02B 1622.0  +
• OuB_BlwSpin,285,2,0,0,False,False,0,7,0,False,0,Y285  +
• Refit all trunking lids and swarf chutes , and internal connections are now complete  +
• Secure copper blower line to original tool break sensor blower as shown. Use Tie wraps to secure Position end as shown , until function testing in operation, where blower end should be positioned for optimum swarf clearance when routing  +
• lower trunking lids and lower chute panel may require removing to install following pipework.  +