Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• <div class="icon-instructions caution-i …
  ...Ensure holes if drilled by hand are sufficiently deburred and free of sharp edges on both sides
  Drill and fit deflector as shown Ensure deflector is mounted at a height that clearance is present between conveyor belt and deflector Provide details to enable ecr to be raised to add mounting holesyor belt and deflector Provide details to enable ecr to be raised to add mounting holes  +
• <u>'''Pictures Required'''</u> Secure with 4 off M5 x 10 socket caps and M5 A form washers  +
• Add 2 off m6 rivnuts to swarf funnel pre drilled holes Ecr raised to add rivnut to drawing 18/12/23  +
• Check all fasteners are finalised and marked Ensure all settings have been finalised  +
• Details and pictures Required Drill and pin funnel in position with 2 off 3 mm spiral pins  +
• Drill M6 clearance holes at marked points Photos and details of this please <u>'''Drill off cable tie bases for motor cable'''</u>  +
• Drive motor must be removed to allow access to fit side sheets 1 locking grubscrew must be slackened to allow drive motor to be removed. Ensure drive motor is refitted after installation of waste guidance sheets  +
• Ensure button head M6 fasteners are used backed with M6 dome nuts  +
• Fit 4 off side sheet as shown Secure using m5 slim D nuts , M5 x 10 socket caps and M5 A form washers At position shown, Use 2 off M5 x 10button heads for clearance when motor fitted  +
• Fit edging strip to top faces please detail  +
• Fit swarf funnel to conveyor brackets Secure with M6 cap heads and washers  +
• Position conveyor end plate as shown Ensure end plate does not touch belt. Needs to be 3mm higher than belt face Mark positions for mounting holes and remove end plate  +
• Use Loctite 243 on all fasteners Use Loctite 572 on all threaded pneumatic connection Pen mark all fasteners to show finalised  +
• When positioning swarf funnel, it is vital that it does not contact the conveyor belt . Please ensure it is set so there is no contact between the two  +
• fit 2 off radius side sheets as shown Secure using m5 slim D nuts , M5 x 10 socket caps and M5 A form washers Position as shown 5mm from edge frame  +