Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• 1 insert shaft into bore following previo … 1 insert shaft into bore following previous step information 2 Insert 0.125mm/0.005" shim between roller and backfence at indicated point 3 Apply very light hand pressure to area shown to position shaft correctly 4 fit and finalise M6 x 10 kcp grubscrew to secure shaft 5 pull out shim from under roller Repeat for all ten rollersnder roller Repeat for all ten rollers  +
• 10 off Fit pre assembled rollers to assembled shafts clean excess grease from shafts once fitted  +
• All bolts to have Loctite 243 adhesive applied unless otherwise stated All Threaded Pneumatic connections to have Loctite 570 applied All bolts to be pen marked once adhesive applied and correct tension added  +
• Apply liberal grease to all bearings within rollers  +
• Assemble 10 off D0005184 Guide Roller E … Assemble 10 off D0005184 Guide Roller Each roller has 2 off B0000245 Needle Bearing fitted Ensure bearings and rollers are thoroughly degreased before fitting Ensure bearings are fitted correct orientation . Writing on edge of bearing should be face outwards Use bearing dolly and push bearing down to should within roller body bearing down to should within roller body  +
• Dimples in H0005185 Shaft are not used in this application. When fitting shaft , position dimple 180 degrees opposing M6 fixing point in backfence  +
• Fit 10 off D0005186 Guide Pin Washer to H0005185 Shaft 12mm: 90.5 Saw Fence Roller Pin Hold shaft in vice and use M5 x 12 socket cap to secure washer to end of shaft . Finalise bolt with loctite 243 Repeat for all ten shafts/washers  +
• Use 1 meter straight edge to check alignme … Use 1 meter straight edge to check alignment of rollers Place straight edge against front face of rollers Use feeler gauges to check Mis alignment of rollers on the plain indicated Rotate rollers individually to check for eccentric rotation. Report any discrepancies above 0.002"/0.05mm to supervisor All rollers should be free moving and consistent when rotatedbe free moving and consistent when rotated  +