Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• Add M0000031 edging strip to servo motor protection plate Fit servo motor in conjuction with protection plate and ensuring servo connection cable is connected Ensure servo plug is orientated correctly  +
• Align and finalise bottom bearing blocks to rotary ring back plate  +
• Check z support bars are installed Y axis leadscrew nut is not positioned in y axis bearing housing Location dowels are fitted to Y axis bearing blocks  +
• Finalise all fasteners on r axis gearbox assembly  +
• Fit 2 off Y axis hard stops  +
• Fit 2 off access plates  +
• Fit 3 off ring bungs  +
• Fit and position lifting strop onto rotary ring Ensure strop is positioned correctly between spindles  +
• Fit oil pots Add ring oil Add pot caps  +
• Fit timing cover  +
• Installation of rotary ring requires the use of the overhead crane Please ensure all safety requirements are met, and all employees are confident with the operation and installation progress before commencing work details  +
• Quality check for correct backlash between … Quality check for correct backlash between drive gears , requires 2 people To complete this Lock gearbox using 8mm hex key positioned in friction coupling of gearbox through access hole Ensure gearbox is held in a fixed position Rock rotary ring to check for presence of backlash. No backlash should be present , only minimal belt flex should be observed Check backlash in 4 points equally spaced around rotary ring rotationequally spaced around rotary ring rotation  +
• Set back lash on gearbox by hand Push gearbox up towards centre of ring by hand and tighten holding fasteners  +
• Slowly lower to correct position within machine centre assembly Height setting is governed by bearing block alignment to back plate of rotary ring  +
• The lifting strop can now be released and removed from the rotary ring  +
• The lower section of the rotary rotary ring will require moving forward to enable r axis gearbox assembly to be fitted Position Gearbox in place , along with R axis servo control cable Light fix R axis gearbox in position  +
• Use M8 sockets to Finalise fixing between bearing blocks and rotary ring back plate Finalise Fasteners  +
• Use locktite 243 on all fasteners Use loctite 572 on all threaded pneumatic connection Pen mark all fasteners to show finalised  +
• Use overhead crane to lift rotary ring assembly to align over the top of the machine centre main frame  +
• Use torque wrench to set correct torque on r axis gearbox friction coupling Fit gearbox blanking plug  +