Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• 1 Attach outfeed side clamp assembly as shown 2 Fix with 4 off M6 x 25 socket caps 3 Ensure block sits correctly in pocket as shown  +
• 1 Use 4 off M8 x 25 socket caps and 4 off … 1 Use 4 off M8 x 25 socket caps and 4 off M8 fat D nuts to fix 2 Ensure clamp is as low as possible in the direction shown 3 Align to datum rollers by using 300mm parallel as shown. Side clamp rollers must all touch the parallel edge. To adjust , release M5 bolts , adjust and reglue and tightene M5 bolts , adjust and reglue and tighten  +
• All fasteners used in the alignment and build up of the clamp assembly should now be quality checked Ensure EVERY bolt is glued and tight and marked Ensure every adjustment grubscrew has loctite 290 applied in situ , to lock in place  +
• Attach outfeed clamp frame as shown 1 … Attach outfeed clamp frame as shown 1 Use 2 of M6 x 35 socket caps and 2 off M6 fat d nuts to fasten 2 Use 2 off M6 x 40 socket caps and 2 off M6 D nuts to secure indicated roller will require removing to fix upright, then refit 3 Ensure uprights are fitted vertical . Use engineers square at indicated point to set vertical position 4 use engineers level to ensure indicated face is level . Ensure one edge of plate remains flush with the top of the maytec sections flush with the top of the maytec section  +
• Fit top clamp cylinder using 2 off M8 x 30 socket caps with heavy washers and 2 off 4mm x 18mm spiral pins  +
• Fit top frame to main frame as shown Use 6 off M10 x 30 socket caps and a form washers to fix  +
• Use locktite 243 on all fasteners Use loctite 572 on all threaded pneumatic connection Pen mark all fasteners to show finalised  +
• Using M8 grubscrews, adjust top clamp so pad is parallel to datum rollers in both plains Use parallels as shown, no movement should be possible in any direction when the top clamp pad is sat on top of [parallel blocks  +