Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.
Liste de résultats
- (front transfer beam removed for clarity ) Fix assembled beam to supports as shown Do not finalise fasteners +
- Attach mounting brackets as shown +
- Once correct settings have been achieved, double check and finalise all fasteners used for adjusting and mounting . Ensure all fasteners have 243 applied to threads and are pen marked as complete +
- Repeat for each individual Sensor and padd … Repeat for each individual Sensor and paddle 1 Place straight edge over transfer beams and above sensor paddle to be set 2 Adjust sensor to touch paddle in this position 3 Wind sensor back 1/2 turn 4 tighten lock nuts to finalise, checking that shakeproof washers have been fitted to sensorkeproof washers have been fitted to sensor +
- Repeat height setting at point B using same criteria Once point B is set, check that point A has not altered +
- Span over transfer beams 1 and 2 with str … Span over transfer beams 1 and 2 with straight edge at point A Lift or lower sensor rail assembly to match the following criteria When straight edge is pushed to meet radius of sensor plate, it must strike at indicated point of halfway around radius on paddled point of halfway around radius on paddle +
- Use Loctite 243 on all fasteners Use Loctite 572 on all threaded pneumatic connection Pen mark all fasteners to show finalised +
- Use sliding adjustment on maytec angles /frame to adjust height of assembly To determine correct height Set end A and B separately +
Français
English
Deutsch
Español
Italiano
Português