Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• 1 Slide drive pinion away from rack , this pinion shou. be loose and free moving 2 Move cylinder rail to position shown 3 Slide Pinion into position under drive rack 4 Adjust Backlash between rack and pinion to give no more than 1mm movement  +
• <br/><div class="icon-instruction …
  
  ...In the following steps, do not rotate the main drive shaft. All the meshing can be achieved by repositioning drive pinion allowing individual rack assemblies to be aligned
  itioning drive pinion allowing individual rack assemblies to be aligned</div> </div>  +
• Adjust delrin wheels on section shown En … Adjust delrin wheels on section shown Ensure to use [[Spécial:AjouterDonnées/Tutorial/Setting Delrin Transfer Table Wheel Tension|Setting Delrin Transfer Table Wheel Tension]] To set delrin wheels correctly
  
  ......Ensure M5 locking nuts are correctly tensioned when set
  
  ">......Ensure M5 locking nuts are correctly tensioned when set</div> </div><br/>  +
• Attach pneumatic jig to cylinders , to enable cylinder pistons to be extended  +
• Check all fasteners are correctly tensioned Ensure all delrin wheels are correctly set and all fasteners on delrin wheels are tensioned to final tension  +
• Double check setting by measuring from cylinder piston to hepco rail on each cylinder assembly All measurements should be the same -+ 0.5mm  +
• Ensure cylinder rail is free moving along transfer beam  +
• Fit hard stop assemblies once alignment is set Fasteners and size required  +
• Mesh requires setting between slider unit and drive pinion It is vital that the correct drive meshing is achieved. Complete the following steps to mesh pinion and drive correctly  +
• Once all settings have been set, Delrin wh … Once all settings have been set, Delrin wheel tension should be rechecked before final sign off All delrin wheels should be set and be able to be stopped from rotating when held with light finger pressure. . Ensure all delrin wheels are checked on transfer assembly to ensure correct settingransfer assembly to ensure correct setting  +
• Once drive racks have been set, it is vital to check that no interference between rack and arm is present. Move racks along full length of travel and check for any fouling  +
• Position Cylinder rail onto transfer beam as shown  +
• Remove safety bolt stop from cylinder rail … Remove safety bolt stop from cylinder rails Adjust delrin wheels on section shown Ensure to use [[Setting Delrin Transfer Table Wheel Tension]] To set delrin wheels correctly
  
  ...Ensure M5 locking nuts are correctly tensioned when set
  
  ext">...Ensure M5 locking nuts are correctly tensioned when set</div> </div><br/>  +
• Remove, apply adhesive and finalise 2 off M6 grubscrew per each drive pinion  +
• Repeat step 10 but with rack in position shown  +
• Repeat steps 10 and 11 for remain 7 off cylinder rails 2-8  +
• Set cylinder rails to hepco rail by comple … Set cylinder rails to hepco rail by completing the following steps 1 Set cylinder rails 1 and 8 to same measurement to hepco beam, using same technique of sliding drive pinion out of the way to enable movement 2 For finer tuning of position, Use slots in rack mounting and drive gear position to adjustmounting and drive gear position to adjust  +
• Set wire line between set cylinders 1 and 8  +
• Sign off Required for all alignment settings  +
• Use Loctite 243 on all fasteners Use Loctite 572 on all threaded pneumatic connection Pen mark all fasteners to show finalised  +