Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.
Liste de résultats
- Adjust bump stop so it makes correctly whe … Adjust bump stop so it makes correctly when cylinder is retracted
strikes in the position shown on the connection block in the photo</div> </div><br/> + - Adjust gripper on mounting arms to align gripper teeth with setting jig Ensure that when adjusting , gripper remains parallel to hepco beam . Check this by measuring the indicated points +
- Backfence height needs to be checked in th … Backfence height needs to be checked in the roller lowered position. To do this 1 Remove air from cylinders to allow rollers to drop 2 Use 2 meter straight edge to span between transfer arms 3 drag straight edge over backfences, straight edge should not touch backfence at any point 4 Check this on all roller beds on module E Check this on all roller beds on module E +
- Channel bar positions now need to be set relative to new gripper position +
- Channel bar should be checked at all swivel points for the correct height setting Adjust height of assemblies to set indicated height to 3-4mm Ensure all measurements are consistent at adjustable points +
- Check that all fasteners are correctly tensioned, have had Loctite 243 applied and are pen marked +
- Double check all fasteners used for adjustment have loctite 243, final tension applied and pen marked '''<u>Supervisor sign off required at this stage</u>''' +
- Ensure all positions of backfences except 1 and 10 are not touching wire line +
- Ensure setting jig is set against position 1 backfences Ensure setting jig is orientated correctly , correct offset of holes towards backfence +
- Fit wire line to backfences to span all +
- Fully extend channel cylinder Move gripper along entire axis 3mm gap between channel bar and gripper should remain consistent at all points '''<u>Supervisor sign off required at this point</u>''' +
- Gripper position requires setting now that back fences are aligned The following steps should be followed for correct alignment +
- Individually adjust each backfence to be less than 0.5mm from wireline but not touching +
- Move gripper to each swivel assembly and adjust base to ensure 3mm gap when cylinder is fully extended Repeat setting process for all swivel arms ( 4 off in total ) +
- Once gripper position is set at position 1, it should be checked at all backfences for consistency Report any discrepancy to supervisor +
- Position gripper in front cylinder assembly for channel bar Adjust base of cylinder so that there is a 3mm gap present between gripper and channel bar, when cylinder is fully extended +
- Set backfence position 1 to have a gap of 3mm at the indicated point +
- Set position 10 to measure taken in previous step from position 1 Tolerance -+ 0.5mm +
- Take measurement at indicated point +
- The first 2 meter section of backfences from position 1 should now be fine tuned with a 2 meter straight edge Position 2 meter straight edge against indicated points +
Français
English
Deutsch
Español
Italiano
Português