Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• <div class="icon-instructions caution-i …
  ...Vital Check is required on sprockets. Check M8 fix hole is tapped all the way through . Do this by winding an M8 grubscrew through the tapped hole, and checking that is enters fully into the 16mm bore in the pulley . Do this check for ALL sprockets
  Check for any internal burrs around tapped holes . If present remove with emery tape Clean 9 off sprockets B0001145 with fe10 solvent and compressed air to remove any debris or contamination
  B0001145 with fe10 solvent and compressed air to remove any debris or contamination <br/>  +
• Check for any burrs or damage . If present remove with emery tape Clean shafts D0015459B and D0015458B with fe10 solvent and compressed air to remove any debris or contamination  +
• Check for any internal burrs around tapped holes . If present remove with emery tape Clean 9 off bearings B0001150 with fe10 solvent and compressed air to remove any debris or contamination <br/>  +
• Check that all bearings slide easily along the entire length of both shafts . Any tight spots should be dressed down with emery tape, cleaned and retried. Repeat until all bearings pass freely along both shafts  +
• Check that all sprockets slide easily along the entire length of both shafts . Any tight spots should be dressed down with emery tape, cleaned and retried. Repeat until all sprockets pass freely along both shafts  +
• Spherical bearings should be greased with grease gun prior to fitting to ease spherical movement and aid installation  +
• Store prepared shafts, sprockets and bearings ready for next stage  +
• Use loctite 243 on all fasteners Use Loctite 572 on all threaded pneumatic connections Pen mark all bolts to show finalised  +