Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• <div class="icon-instructions info-icon …
  ......Roller beds have been removed from image for clarity of position of sprockets
  Install shafts from the directions shown , adding the B0001145 sprockets in their correct positions, as the shafts pass through the bearings . Do not close the gap between the 2 shafts in the centre of the machine until the next step is observed the gap between the 2 shafts in the centre of the machine until the next step is observed  +
• <div class="icon-instructions info-icon …
  ...Roller beds have been removed from image for clarity of position of sprockets
  Prepare sprockets to fit when shafts are installed Sprocket B0001145 will require adding to shaft as it is fitted to main frame. Each arm will have a sprocket fitted in the position shown (1)t is fitted to main frame. Each arm will have a sprocket fitted in the position shown (1)  +
• Attach 9 off B0001150 to load arms as sho … Attach 9 off B0001150 to load arms as shown . ensure correct position is used for mounting of bearings . Use 2 off M8 x 30 socket countersink fasteners per bearing to align and fix to arms Ensure greasing point of bearing is facing towards the front of the machine as shown towards the front of the machine as shown  +
• BFit shaft coupling B0001152 to one of sha … BFit shaft coupling B0001152 to one of shaft at the final stage of fitting. Gap between shafts should be approximately 2mm Once this is achieved fit 2 off b0000041 ( 1 to each shaft) align and tighten coupling in position Overall position of the now combined drive shafts, bearing grubscrews and spockets will be finalised in a later dokitockets will be finalised in a later dokit  +
• Orientation of drive shafts is as follows 1 D0015459b orientated as shown 2 D0015458b orientated as shown Each flat on the shafts if orientated correctly will align with an arm position on the frame <br/>  +
• The build sequence has been amended to make fitting of drive shafts easier . Roller beds are now fitted AFTER drive shaft installation Please take photos to amend following steps for clear instructions  +
• Use loctite 243 on all fasteners Use Loctite 572 on all threaded pneumatic connections Pen mark all bolts to show finalised  +