Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.
Liste de résultats
- 1 Mount assemblies as shown using M8 x 25 … 1 Mount assemblies as shown using M8 x 25 socket caps and heavy M8 washers. Do not apply Loctite 243 at this stage to bolts Only apply enough tension to fasteners to hold roller assemblies true to the mounting face (Blue section) 2 Attach R0015081 using the same fasteners as above. Ensure the slots are used to align to the other roller bed assemblies as shown the other roller bed assemblies as shown +
- 1 Remove m8 Socket Caps individually on ea … 1 Remove m8 Socket Caps individually on each roller bed as it is being adjusted for height and apply Loctite 243 2 Place 2 off 2mm shims on top of green runner strips as indicated 3 Span across these with 2 meter straight edge 4 Lift roller assembly up to align with bottom face of straight edge 5 Tighten and finalise M8 Fixing boltsge 5 Tighten and finalise M8 Fixing bolts +
- All bolts to have Loctite 243 adhesive applied unless otherwise stated All Threaded Pneumatic connections to have Loctite 570 applied All bolts to be pen marked once adhesive applied and correct tension added +
- Attach Air feed jig to all roller bed assemblies Please add pictures of this step please +
- Once all roller beds have been mounted and … Once all roller beds have been mounted and aligned , use the 2 meter straight edge to travel across the entire length of the finalised roller beds Transition should be smooth between roller bed assemblies, with no bumps or drops onto roller beds from previous ones '''Supervisor sign of required''' '''<u>Supervisor sign of required</u>''' +
- Repeat step 5 for all other roller bed assemblies except R0015081 using the same method To level R0015081 place shims at points indicated and extend straight edge over to allow height setting +
- See Pictures for R0015081 and R0015090 roller bed locations +
- Using the cylinder stroke, Roller bed asse … Using the cylinder stroke, Roller bed assemblies will need to be adjusted to a level position 1 Place engineers level above support bracket as shown 2 Wind back cylinder lock nut and apply Loctite 243 to thread of cylinder 3 Adjust cylinder stroke to achieve level 4 Lock off cylinder nut and confirm level has been maintained , if not adjust and tension lock nut. 5 (Skip to step 6 if a single bracket roller assembly ) Repeat on Second Bracket attached to assembly . Previous bracket setting must be checked after adjusting second bracket. Confirm both are level 5 Mark Lock nut as complete when final setting is complete and locked offn final setting is complete and locked off +
Français
English
Deutsch
Español
Italiano
Português