Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• 9 off Combine as shown D0015619 and D0015620 using M8 x 30 socket caps, M8 heavy washers and M8 nyloc nuts Orientate as shown in picture  +
• 9 off D0015456B load arm needs preparing before assembly. All tapped holes require contaminants removing before assembly. Use appropriate taps to clean all threads on load arms  +
• 9 off 1 Attach chain guide D000125 … 9 off 1 Attach chain guide D0001256 as shown using 5 off M4 x 12 socket caps 2 Attach lower channel D0002943 as shown using 4 off M5 x 10 button heads
  ...Do Noy fit fastener to indicated hole. This is the securing hole for green wear strip fitted later on
  3 Slide plastic guide into channel and fix with M5 x 12 socket cap and A form washer
  ide plastic guide into channel and fix with M5 x 12 socket cap and A form washer <br/>  +
• 9 off 1 Use press to fit bearing B000 … 9 off 1 Use press to fit bearing B0000252 to idler pinion D0007576. Ensure bearing fit is correct. If bearing is loose, degrease with FE10 solvent and use bearing fit to secure bearing . If bearing is tight, measure bore and report via NCR system if out of tolerance . Retain bearing with 47mm internal circlip 2 use press to insert D0007577 into bearing as shown. Ensure fit is correct. Use FE10 solvent and bearing fit if loose, if tight measure and inspect and report through NCR system. Fix in place with a 20mm external circlip Fix in place with a 20mm external circlip  +
• 9 off 1 Attach tensioner pinion to assembly using M8 x 35 socket cap and M8 motorplate washer 2 Add M8 x 100 set bolt and M8 nut to the indicated face  +
• 9 off Add 8mm x 24mm spirol pin to indicated hole <br/>  +
• 9 off Use 4 off M6 x 30 countersink bolts to attach tensioner assembly to loading arm Insert jacking tensioner D0002999 into each assembly when fitted to arms  +
• <div class="icon-instructions caution-i …
  ...Ensure shafts D0002717 are orientated correctly. Holes are offset different at each end
  9 off Assemble as shown the following with no fixings D0001255 D0002717 D0001253 D0001254 Ensure D0001255 slides along shafts once assembled001255 D0002717 D0001253 D0001254 Ensure D0001255 slides along shafts once assembled  +
• Use loctite 243 on all fasteners Pen mark all fasteners once finalised  +