Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• 1 off 1 Attach D0015561 to D0015562 as shown using 3 off M8 socket caps (size required) 2 Mount assembled sprocket plate using M6 x 30 socket caps and heavy F0000247 M6 washers  +
• 1 off 1 Insert 3 off B0001100 key into driveshaft 2 Insert driveshaft D0015024 as shown and captivate either side with external circlip (size required)  +
• 1 off 1 Press bearing B0000139 into sproc … 1 off 1 Press bearing B0000139 into sprocket H0007576. If fit is loose, use FE10 solvent to degrease parts and apply bearing fit to fix. If fit is tight, inspect parts to Drawing to confirm correct sizes 2 Press D0007577 into sprocket and follow above for correct fitment . 3 Captivate with 20mm external circlip . 3 Captivate with 20mm external circlip  +
• 1 off Attach sprocket assembly to D0015626 Using M8 Socket cap (length Required)  +
• 1 off Mount clutch assembly as shown and captivate with 25mm external circlip ECR raised 12/06/23 to address problem of grubscrew lock off missing key fitted. Until corrected , use M6 x 10 kcp grubscrew to lock on to shaft  +
• 2 off Attach motor to base as shown Use … 2 off Attach motor to base as shown Use M8 hex set bolts , A form washers and M8 nyloc nuts to secure 4 off mounting points (Bolt Length required)
  
  Ensure fasteners are long enough to pass through nyloc section of nut
  
  ure fasteners are long enough to pass through nyloc section of nut</div> </div><br/>  +
• 2 off per assembly 1 off assembly Use M1 … 2 off per assembly 1 off assembly Use M12 x 100 hex set bolts (check size) and A form washers to attach 2 off clamp plates D0015610 to assembly as shown
  
  ......Do not apply adhesive to these as they will be removed for installation later on
  
  dhesive to these as they will be removed for installation later on</div> </div><br/>  +
• Check B0000229 has been assembled in the correct order 1 C Spanner pressure nut 2 Locking washer 3 Spring washer 3 off 4 Spreader plate 5 Friction washer 6 Centralise boss 7 Drive sprocket 8 Main Flange  +
• Check motor has been supplied in the shown configuration. Gearbox may need rotating on supplied motor assembly to match orientation shown. Motor terminal box position is vital  +
• It is vital that the alignment bush can pass through the drive sprocket by hand  +
• Use Loctite 243 on all fasteners Use Loctite 572 on all pneumatic threaded connections Pen mark all bolts to show finalised  +