Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.
Liste de résultats
- '''Only fit one sensor lock nut and shakeproof washer to assembly as shown''' Fit E0000336 sensor to assembly Leave 10mm protrusion from top of bracket as shown Ensure shakeproof washer is fitted under sensor nut +
- All bolts to have Loctite 243 adhesive applied unless otherwise stated All Threaded Pneumatic connections to have Loctite 570 applied All bolts to be pen marked once adhesive applied and correct tension added +
- Attach u bolt and sensor bracket on infeed mounting pillar Fix with M12 nuts and M12 A form washers Ensure bracket is mounted square to pillar base, only apply light tension to M12 nuts +
- Finalise M12 nuts and ensure U bolt assembly is mounted true as to not impact on side sheet guarding panel when fitted later Check sensor position has not moved +
- Set Height of U bolt bracket assembly in relation to flag on saw motor plate, to set sensor withing +- 2mm of flag +
- Set sensor height to minimal clearance (-1mm ) Check gap is consistent on full travel over sensor flag when head is rotated +
- once finalised, double check correct operation of sensor. Sensor should be within -1mm at all points of travel onto SR axis datum flag. Sensor should NEVER be in contact with flag at any point of movement +
Français
English
Deutsch
Español
Italiano
Português