Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• 1 Set hole position A to middle of moveme … 1 Set hole position A to middle of movement in direction shown 2 Use engineers level on indicated face and adjust position B up or down to set rail level 3 Remove central fasteners one by one, applying adhesive and adding final tension. Then remove both end fasteners ,apply adhesive and apply final tension Repeat for all remaining 5 linear rails
  t for all remaining 5 linear rails <br/>  +
• Attach B0000046 bearings 6 off to linear r … Attach B0000046 bearings 6 off to linear rails orientated as shown Use M6 x 16 socket caps and M6 A form washers with adhesive and lightly fasten as shown , ensure mounting brackets are free to move to align to the bearing face . Once all faces are in position, tighten all fasteners with adhesive and finalisen all fasteners with adhesive and finalise  +
• Attach D0015492 Vertical Beam Adjustment P … Attach D0015492 Vertical Beam Adjustment Plate x 5 and D0015493 Lateral Beam Adjustment Plate x 5 to positions shown Use M10 x 20 and M10 x 30 set bolts, M10 A form washers And nuts on joining plates Pay attention to orientation of position 3 only apply light pressure to fasteners to hold in place bracketsure to fasteners to hold in place brackets  +
• Brackets require fixing with 8mm x 24mm roll pins Drill the indicated faces to secure alignment All 5 bracket sets required pinning  +
• Fit 6 off B0001006 linear rails to hepco b … Fit 6 off B0001006 linear rails to hepco beam as shown Use data for position of each rail Fix with F0000331 m6 threaded plates and m6 x 20 socket caps with no adhesive ( holding stock of F0000331 plates is available from stores via request ) only apply light pressure to 2 off fixings per raily light pressure to 2 off fixings per rail  +
• Now alignment is complete, the finalising dowels supplied with the hepco rail can be fitted in the areas shown  +
• Quality check required from supervisor before next step commences  +
• Setting jigs can now be removed that are supporting hepco rail in 5 positions Fit B0000173 blanking plugs to linear rails. Ensure plugs are fitted flush to rail face, not below Grease all linear bearings on hepco rail  +
• Use Loctite 243 on all fasteners Use Loctite 570 on all threaded pneumatic connections Pen mark all bolts once finalised  +