Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• <div class="icon-instructions caution-i …
  ...F0000185 M6 x 16 Hex set S/S bolt is used as a stop .It is vital that this part is not set any further into the assembly than described in the steps below
  Position assembly as shown Fit M6 set bolt by hand Slowly adjust set bolt by winding into the assembly until the shown position is achieved by the base and arm when Head of set bolt contacts the clacker base DO NOT SET ANY FURTHER THAN THIS POSITIONen Head of set bolt contacts the clacker base DO NOT SET ANY FURTHER THAN THIS POSITION  +
• Check list Pin centralised Set bolt adjusted Clacker arm and base pivots on pin by hand  +
• D0008339 Gap Closer Arm x 1 D0008340 Gap Closer Base x 1 D0008496 Clacker Pins x 1 F0000185 M6 x 16 Hex set S/S x 1  +
• Drive pin through parts until flush with face  +
• M0000101 is not required for bench assembly , and will not be shown within the work instruction . Ensure this part is issued with each assembled clacker  +
• Position D0008339 Gap Closer Arm as shown … Position D0008339 Gap Closer Arm as shown
  
  ...It is vital to orientate this part correctly . Note the offset between the arm and base when orientated correctly
  
  Note the offset between the arm and base when orientated correctly</div> </div><br/>  +
• Use a 5mm punch and ball pein hammer to centralise pin between the 2 outer faces of D0008340 Gap Closer Base  +
• Use ball pein hammer to locate D0008496 Clacker Pins into D0008340 Gap Closer Base as shown Ensure pin does not go past indicated face  +