Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• 1 Fit 2 off D0004545 Slide Support End an … 1 Fit 2 off D0004545 Slide Support End and fix with M8 x 20 socket cap and M8 x 12 kcp grubscrew per side . Do not finalise fasteners 2 Align end plates as shown using straight edge , to set end plates flat to each other 3 Finalise fixings and recheck end plate position has been held with straight edge position has been held with straight edge  +
• 1 Degrease 4 off D0004138 Centralising Bea … 1 Degrease 4 off D0004138 Centralising Bearing Block 2 Use press to fit4 off B0000034 Linear Bearing. Fit bearing so yellow seal is almost flush with bearing block face
  ...Check that ball chambers are not visible
  3 Apply grease to bearings that ball chambers are not visible</div> </div> 3 Apply grease to bearings  +
• 1 Identify 2 off D0005236 Support Post. Ch … 1 Identify 2 off D0005236 Support Post. Check length measures 160mm 2 Use loctite 270 and fasten a length of M8 studding into one end and tighten 3 Cut M8 studding with hacksaw to leave 12.7mm protrusion as shown 4 Fit studding to other end using steps above but cut to 36mm 5 Repeat for second support bar 6 quality check cut threads. Threads should be dressed clean with a file once cut . Use an M8 nut to check quality of thread before fitting to assemblyality of thread before fitting to assembly  +
• 1 Orientate D0004337 Slide Bar Holder as s … 1 Orientate D0004337 Slide Bar Holder as shown and fit 2 off H0004624 Shaft 16mm: 343 and secure with 2 off M x 12 kcp grubscrews , ensuring dimple on shaft is correctly aligned with grubscrew 2 Fit 2 off bearing blocks as indicated . Fit 2 off pre assembled support bars as shown, using Loctite 243 3 Fit D0004338 Slide Support Bar and orientated as shown. Ensure M8 grubscrew holes face downwards as shown . Use hide hammer to creep bar evenly into position 4 Fit 2 off D0005235 Support Post as shown and finalise 5 Fit 2 bearing blocks orientated same as previous two fittedcks orientated same as previous two fitted  +
• All bolts to have Loctite 243 adhesive applied unless otherwise stated All Threaded Pneumatic connections to have Loctite 570 applied All bolts to be pen marked once adhesive applied and correct tension added  +
• Fit 4 off M8 x 12 flat bottomed grubscrews as shown Fit 4 off Mx 20 kcp grubscrews as shown  +
• Fit Large black tie base and secure with M5 x 10 button socket Orientate as shown  +
• Please images for orientation of builds  +
• Use 16mm hand reamer to check sizing of bores in following parts 1 D0004545 Slide Support End x 2 2 D0004338 Slide Support Bar x 1 3 D0004337 Slide Bar Holder x 1  +