Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

<u>'''Cut 1 off piece of M5 studding to 85mm'''</u> Attach studding to magnet block, use loctite 243 and M5 nuts to lock into position, ensuring position of markers is retained when the clamp is fully open +
Clearance in mounting block M5 fixings sho … Clearance in mounting block M5 fixings should be used to ensure correct alignment of ball joint, studding and fixing block. Finalize M5 nuts onto ball joint and mounting block. Then release tension on 2 off M5 socket caps holding mounting block on then re-tension. This will correctly set alignment between the 3 componentstly set alignment between the 3 components +
Dry fit magnet mounting block +
Ecr raised 15/08/23 to create new part for additional spacer block required If not issued, part will require making until new parts are processed See drawing for details 2 off required +
Ensure side clamp movement is not hindered … Ensure side clamp movement is not hindered by attached width sensor assembly Check when clamp is retracted magnet block aligns perfectly onto indicator mark on linear sensor Check magnet block is orientated correctly ( cable indicator is facing cable )rectly ( cable indicator is facing cable ) +
Final fit magnet mounting block to clamp assembly Finalise locking nut on studding +
Fit mounting brackets and spacers Ensure to fit supplied top hat bushes Use longer M5 socket caps to captivate bracket and spacer +
Set position of magnet ball joint to align with indicator mark on linear sensor Ensure side clamp assembly is fully retracted +
Slide into position linear sensor Ensure plug connection is facing towards trunking +
Slide on captive magnet ball joint Ensure correct orientation, Use pictures for guidance for correct positioning Part will indicate which face has to face towards the cable end of the sensor +
Use locktite 243 on all fasteners Use loctite 572 on all threaded pneumatic connection Pen mark all fasteners to show finalised +