Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• 1 Remove 1 off Long M8 socket cap and ten … 1 Remove 1 off Long M8 socket cap and tension an M8 x 12 kcp grubscrew into the hole (do not add adhesive ) 2 Remove second Long M8 socket cap and dimple inner shaft using 6.8mm drill Clean with compressed air and add M8x 8 kcp with adhesive and tension 3 Remove m8 x 12 kcp grub screw and repeat above step x 12 kcp grub screw and repeat above step  +
• 1 Add m8 socket caps as shown to hold asse … 1 Add m8 socket caps as shown to hold assembly in vice 2 Use 2 off m8 long socket caps and Standard M8 nuts and lock onto drive coupling .
  
  ...Ensure end of socket cap doesn't touch inner part as rotation is required to tension
  Tension using long M8s as leverageas rotation is required to tension</div> </div> Tension using long M8s as leverage  +
• 1 Check and adjust fit of B0000139 Double … 1 Check and adjust fit of B0000139 Double Angular Bearing 20 D 47 D 20.6 Long + seals x 1 onto D0006488 Y Leadscrew Sleeve x 1 2 Fit should be a smooth press fit onto sleeve. Indicated face can be polished down with fine emery to obtain desired fit
  ...Only polish a small amount at a time , to ensure to correct amount is taken of the sleeve
  nt at a time , to ensure to correct amount is taken of the sleeve</div> </div>  +
• 1 Check bearing B0000086 Ball Bearing 15 D 32 D 9 Long + seals fit is acceptable on leadscrew H0007789 2 Adjust with emery tape if fit is tight  +
• 1 Check fit of coupling to leadscrew H0007789 2 Use reamer / Emery tape if fit is tight  +
• Ensure D0001926 Servo Drive Coupling M20 (Ø14mm) Beckhoff x 1 fits onto C0001122K Servo Motor: Beckhoff AM8032-1E10 (Keyed) x 1 Fit should be a snug slide fit Part can be reamed with hand reamer if fit is tight  +
• Fit B0000236 90 Deg Grease Nipple M6 ST/ST x 1 as shown Check Leadscrew nut is orientated correctly , rotate using leadscrew jig if incorrectly orientated  +
• Use locktite 243 on all fasteners Use loctite 572 on all threaded pneumatic connection Pen mark all fasteners to show finalised  +